Release Version 0.3.2 Beta

PagePosted by Michael Möller on May 19, 2011
  • Fixed the message box that is shown when the Open Hardware Monitor is started without extracting all files from the archive.
  • Fixed a spelling error in the report submitting dialog.

56 Responses to “Release Version 0.3.2 Beta”

1 2 3 4 5
  1. Paul says:
    October 16, 2011 at 2:04 PM

    A few hours later .

    The second card temperature shows up just after booting up and then disappears after a few seconds as it closes the card off if not being used , i used the logging function in a game and was pleased to see the both temps logged for the hour trial and within 5c of each other too!

    cheers….

  2. Paul says:
    October 18, 2011 at 5:03 AM

    More info–
    I’m using a GA-990KXA-UD3 MB and the CPU temp was too low in OHM , and looking about in OHM i see a defaut tick on the sensor , i added a 12 there and all ok now , confirmed it with the manufactuer’s program (which has no gadget!)
    Good one 🙂

  3. Paul says:
    October 18, 2011 at 8:49 AM

    oops , 990FXA-UD3

  4. Rodrigo says:
    October 18, 2011 at 9:20 AM

    Man, I downloaded this accidentaly, but I will use it forever now, love how it’s simple and full of useful information, thank you very much.

  5. Elmagno says:
    October 18, 2011 at 1:25 PM

    What’s so fascinating here? There are much better and freeware monitoring tools around like HWiNFO32 or HWiNFO64 (www.hwinfo.com) which support at least ten times more sensors and features.

  6. Paul says:
    October 19, 2011 at 9:13 AM

    HWiNFO64 — whilst informative , has a Gadget that obviously is ported from DOS! , very poor imo .
    This Gadget here looks Cooooooool .

  7. Paul says:
    October 19, 2011 at 9:15 AM

    BBR and ilr who are the same , please attend doctor , medication serious is required , Japanese medication.

  8. Venom says:
    October 20, 2011 at 3:32 PM

    Nice programm that much ppl are using me also. But i miss 2 kinds here 1st. maybe add the Tjmax from the CPU and the 2nd. how much RAM is used im moment.

    greetings 😉

  9. Rodrigo says:
    October 21, 2011 at 5:18 AM

    An installable version would be very welcome, as well as a gadget feature that always runs in the background.

  10. Rain1 says:
    October 26, 2011 at 6:42 AM

    I really love your software. It has almost all the info of my system that I need to check.

    Some few stuff in my mind right now:

    * RAM’s info (timing, frequency and voltage).
    * CPU & RAM multiplier
    * Bigger icons & fonts (and/or bold fonts) for headlines such as: Motherboard, CPU, Graphic card’s names (to add hierarchy to the tree list)

    Again, thank a lot for the free software (& provide free support) 🙂

1 2 3 4 5